Automatic 6-digit numerator, ready for use Traxx AN6606

Metal automatic 6-digit numerator Traxx AN660 (4.8 x 2.5mm) for sequential numbering: 0,1,2,3,4,5,6,12
Traxx AN6606 (China).

Alternative => Numberer B6

Instructions for use:
Automatic numbering machine.

Storage conditions.
The machine must be placed in a box when not in use. The chrome part must often be cleaned with petrol or kerosene oil. If necessary, disassemble the machine once a year.

Caution when using the machine.
Hold the machine firmly, but it is not advisable to use too much force as if you were using a hammer, because you want to make the machine as durable as possible. When printing, always place the machine on a flat surface, and one or two layers of paper are recommended under it for better printing results.
Before changing the number type or refilling the ink, hold the Security Plate in the desired position by pushing the handle slowly down with your right palm, while pushing the Security Plate slightly forward with your index finger and pushing the handle further down until it reaches the position where it does not move. back.
You can now change the number type or refill the ink.
Then press the handle again and it will return to its normal position.

Change the number type.
When the handle of the machine is held down and the Safety Plate is working, you can hold the machine in the inverted position and change the digit type using a plastic stylus. Let's say you don't have all 6 digits, just change the number you want and reset the other numbers to zero. To press the number zero with the plastic stylus, slide it slightly forward and slide it back slightly in the same way. This zero number will sink down and stop working.

Change of activity.
This numbering device can be set to operate sequentially, to perform two or three operations simultaneously and to perform the same operation 6 times. In addition, it will repeat the movement and in certain cases the same operation may occur 12 times.